How To Install Training Wheels:

1.TOOLS YOU WILL NEED:
a) 15mm Wrench
b) Adjustable Wrench

2.Hardware Included:
x2- Small Bracket Brace Plates
x4- Nuts
x4- Washers
x2- Serrated Washers
x2- Shoulder Bolts
x2- Vertical Brackets
x2- Wheels

3.Installation Instructions:
1).Attaching Wheel to Vertical Bracket
Assemble pieces on shoulder bolt in the following order:-Wheel – Flat Washer- Nut – Vertical Bracket, Flat Washer, Serrated Washer – Nut
2).Attaching Assembled Training Wheel and Bracket to Bicycle
a) Remove axle nit and washer from bicycle axle.Axle washer and nut removed
b)Place Bracket Brace Plate over bike axle by inserting the tab into the open space of the bike frame.
c)Place assembled training wheel onto bracket brace plate and adjust bracket height.
No nut between Bracket Plate and Vertical Bracket
d)Replace axel washer and nut, and tighten securely.

Product Features

• Universal: This practical training wheels, with 12″,14″,16″,18″,20″individually height adjustable holes,universal fitting all 12″ – 20″ Wheel Bicycles with single speed only.
• Function: Stabilizer wheel kit can provide the necessary security and stability which it needs in the first road tests on the bike. Gives your child the best start to gaining their balance and confidence on two wheels.
• Material: Made of high quality ABS+Steel material, and our Estink training wheels support rods are updated to 3.0mm,while the old support rods are 2.5mm.This new one will be more strong and stable for training.
• Installation: When installing the training wheels,you need to place the limit block inside properly.One side of limit block is with a prominent corner and it need to be stuck in the frame.And need to pay attention to the bilateral balance, generally slightly higher than the rear wheel 0.5-1CM and higher than the ground about 0.5cm.Please note that do not install too high or too low from the ground and must tighten the screws before ride
• Wheel Size: Dia.11 x W2.6 cm/4.33 x 1.02inch,Bracket: L23 x W3 x0.3cm/9 x1.18 x0.12inch.